地脚基本解释

汉语拼音:dì jiǎo

1.书页下边的空白处。

2.用于“地脚螺丝、地脚螺栓”。指把机器等紧固在地面上用的螺丝。

3.〈名〉地基。

地脚详细解释

  1. 犹当地。

    宋 文天祥 《提刑节制司与安抚司平寇循环历》:“大概平贼,全要地脚土兵之谓也。今本军以客军望望而前,固已失之。”

  2. 书页下边的空白边。

    清 龚自珍 《与吴虹生书》之十二:“外有地脚一纸,乞致 绣山 弟,此时断断不暇作书与 绣山 矣。”

  3. 方言。地基。如:打好地脚就垒墙。

地脚双语翻译,地脚在线翻译例句

    • The price is too high, and moreover, the house isn't in a suitable position.

      这幢房子价钱太贵, 再者地脚也不好.

    • The holes of anchor bolts will be grouted with normal ( Portland, non - shrinkage ) cement mortar.

      这些地脚螺孔将灌入普通 ( 波特兰, 无收缩 ) 水泥砂浆.

    • After seven days , the grouted mortar will have concreted, then we shall tighten the anchor bolts.

      灌浆在七天以后凝固, 我们就将拧紧地脚螺栓.

    • On the floor beside the bathtub there is a bath - mat.

      在浴缸旁的地面上有块地脚巾.

    • Fix the connection plate of foundation bolt with nut.

      将地脚螺栓连接板用螺母紧固.

    • To lower the balance , turn front leveling feet counterclockwise.

      电子天平下降, 左旋前面地脚螺栓.

    • We usually stand on it while drying.

      一般浴后站在地脚巾上擦身.

    • Machines are stationary on the floor without anchors.

      安装机床不需设置地脚螺栓与地面固定.

    • Error is found . impeller is not balance . Tile pump shaft is not concentric with the motor.

      泵发生汽蚀; 叶轮不平衡;泵与电机不同心;地脚螺栓松动.

    • Should be installed on fixed ( mixed ) concrete foundation with anchor bolt to ensure ni shaking ( viberation ) during ( when ) working.

      1混合时必须用 地脚 螺栓安装在混凝土基础上,以保证工作时不致有震动.

    • Before fixing, check the applicability between tail bolt hole and the pedestal tail bolt.

      安装前应检查地脚螺栓孔与底座螺栓孔是否相符.

    • Tail bolt must use locking device, to prevent the bolt becoming flexible and damaging the motor.

      地脚螺栓采用防松装置, 以防螺栓松动,使电机损坏.

    • Machine are stationary onfloor without anchors . Therefore the installation cost and time can be greatly saved.

      安装机床不需设置地脚螺栓与地而固定,节省安装费用,缩短安装周期.

    • By changing the cutter location will enable printing size change bottom side of the head.

      通过改变切刀位置可使印品天头地脚尺寸改变.

    • The embedded anchor bolts for equipment foundation shall be installed and fixed with positioning forms.

      设备基础的预埋地脚螺栓采用定位模板安装固定.