难检字字典在线查询

汉语拼音：yú liàng

1.一部机器的配套部件（如轴与轴承）之间的容许的公差。

2.在瞄准冰上溜石游戏中的石头时把它的偏离直线路经考虑在内的余量。

• Actually, the amout of maximum stability is also a function of center of gravity travel.

  实际上, 最大稳定性余量也是重心移动量的函数.

• The machining allowance for steel plate thickness refers to above standards.

  钢板厚度加工余量按照以上标准执行.

• Cut the elastic, leaving a 2.5 cm ( 1 inch ) tail .

  留 2.5cm 余量剪断松紧带.

• Margin of safety for a corporation % 26 rsquo ; s financial ratios.

  保证一家公司的财务比例所需的安全 余量.

• Compared to end milling, the cutting allowance was deceased dramatically.

  相对于端铣加工, 该方法大幅度减小了切削余量.

• Online booking ticket price depends on the seat cushion.

  机票价格取决于网上预订的座位余量.

• The method to select the machining allowance of laser cladding was formulated.

  为确定激光熔覆层的加工余量提供了依据.

• Precision forging is normally taken to close - to - final form or close tolerance forging.

  精密锻造技术通常可以称为小余量锻造技术或最小公差锻造技术.

• This cushion is being squashed in a number of ways.

  很多地方都需要这些留出的安全余量.

• Therefore appropriate buffers need to be installed in front of these machines.

  因此需要安装必要的余量缓冲.

• It is machinable for the thicker of POM.

  5、表面塑料层在加工成型时可留一定的余量,装配压入座孔后可自行加工,以达到更好的装配尺寸.

• For instance, when using flat - bottomed cutter to process curved surface, negative margin cannot be offered.

  如在使用平底刀做曲面加工时, 不能给负余量.

• The back engagement of the cutting edge is determined by the machining allowance.

  粗加工时,一次走刀应尽可能切掉全部余量,在中等功率的机床上,可达.

• The method of designing the loop filter with the phase margin and loop bandwidth is displayed.

  并提出了从环路带宽和相位余量出发设计环路滤波器的方法.

• Here the workpiece structure by analyzing, precision analysis, residual analysis, structure, process analysis.

  在这里通过对工件图形结构分析 、 精度分析 、 毛坯余量分析 、 结构工艺性分析.